Setting The Time Unit (Time); Erasing The Scene (Zero) - High End Systems Studio Spot 250 User Manual

Note: The delay value determines the length of the scene. If you want all
motor transitions to be completed before the next scene begins, XFAD
must be less than or equal to DLAY. If XFAD is longer than DLAY, the
transition will not be completed before the next scene begins. Set the
unit of time used for delay (seconds, minutes, or hours) using the TIME
construct.

Setting the Time Unit (TIME)

1. Using the <Up> and <Down> arrow buttons, scroll to the "TIME"
construct and press the <Enter> button to select the time construct.
2. Using the <Up> and <Down> arrow buttons, scroll to the desired time
value (in this example, "SEC") and press the <Enter> button to select the
desired value.
Note: This construct sets the unit of time used in for the XFAD values.

Erasing the Scene (ZERO)

1. Using the <Up> and <Down> arrow buttons, scroll to the "ZERO"
construct and press the <Enter> button to select the zero construct.
2. The LED will display "OK?" (In this example, press the <Menu> button.)
Pressing the <Menu> button will exit this construct and leave the current
scene as programmed. Pressing the <Enter> button will erase the scene
and mark the end of a loop.
Creating a Loop
A loop is a series of programmed scenes that continuously plays in sequential order.
To create a loop, you must first create two or more contiguous scenes (see "Creating a
Scene - Step By Step Example" on page 5-3). After you have created your scenes, go
to the next available scene and choose the "ZERO" menu option to erase any
programmed construct values and mark the end of a loop.
Note: If you program all available on-board scenes, you do not have to mark
the end of the loop. When preset playback is set on, the fixture will
automatically loop after playback of all programmed scenes.
®
Studio Spot 250 / Studio Color
®
250 User Manual Preset Programming
5
5-9