Figure 7-15. Replacing A Static Litho - High End Systems Studio Spot 250 User Manual

toward the bottom litho, you can produce moiré effects. If the coated
side of the top litho is facing away from the lamp, you can produce
morphing effects. For more information, see "Litho Position" on page
5-9.
10. To replace a static litho, gently spread the outer edge of the wheel apart and
slide the static litho into the wheel. Make sure the static litho is seated in the
two retaining slots and that the gap between the edges of the wheel is uniform
(see Figure 7-15).
To replace a rotating litho, place the litho into the wheel housing and place
the aperture ring (if applicable) over the litho.
11. Install the metal spring by inserting the spring into the wheel housing (over the
litho and aperture ring) and rotating the spring while pressing down. When
®
Studio Spot 250 / Studio Color
gap on the edge
of the wheel
retaining tabs
(inside the edges
of the wheel)

Figure 7-15. Replacing a static litho.

®
250 User Manual General Maintenance
7
7-11