Mounting The Fixture Upright; Mounting The Fixture On A Truss; Truss Or Other Support System; Figure 1-13. Rubber Feet On The Fixture - High End Systems Studio Spot 250 User Manual

Maintain a minimum distance of 1 m (3.28 ft.) from lighted
object. This means the fixture must be positioned at least 1
meter away from the object it is illuminating.
Do not mount on a flammable surface.
Use a secondary safety cable when mounting this fixture.
You can mount Studio Spot 250 or Studio Color 250 fixtures either upright (on the
fixture's base) or in any orientation suspended from a support system (such as a truss).
Follow the instructions below for the mounting orientation you choose.

Mounting the Fixture Upright

To mount the fixture upright, make sure that all four
rubber feet are installed on the fixture's base (see Figure
1-13) and place the fixture on a sturdy, stable surface. If
the surface is above floor height, use safety cables to
secure the fixture to the surface (see "Safety Cable" on
page 1-14).
Install the safety cable(s) by looping the cables around a
support on the surface, through the side holes in the
fixture's base, and around the fixture's handles (see
Figure 1-14). Make sure the support and cables can
support the weight of the fixture (see "Physical
Specifications" on page intro-4).
Caution: Do not mount the fixture upright
without the four rubber feet installed.

Mounting the Fixture on a Truss

You will need:
• safety cables (2)
• clamps (2)
• locking washers (2)

• truss or other support system

Truss or Other Support System
If you are mounting the fixture(s) on a truss or another type of support, verify the truss
or support will handle the weight of all the devices you are mounting. The Studio
1-12 Setup and Installation
®
Studio Spot 250 / Studio Color
rubber feet
Figure 1-13. Rubber
feet on the fixture.
®
250 User Manual