Mounting The Fixture Upright; Truss Mounting - High End Systems DL.3 User Manual

Mounting the Fixture Upright

CAUTION!
Do not mount the fixture upright without the four rubber feet attached.
To mount the fixture upright, place the fixture on a sturdy, stable surface that will support more
than the 63.5 kg (140 lb) weight of the DL.3 fixture. If the surface is above floor height, use
safety cables to secure the fixture to the surface.

Truss Mounting

When mounting the fixture on a truss or another type of support:
• Verify the truss or support will handle the combined weight of all the devices on the truss.
• Always mount the DL.3 fixture with the mounting bracket assembly that shipped with your
fixture and a safety cable attached (using the mounting bracket) to the fixture's base.
WARNING!
Before mounting, disconnect power to the fixture. If it has been
operating, allow the fixture to cool for five minutes before handling.
CAUTION!
Only experienced lighting personnel should attempt to hang a lighting
fixture to an appropriate theatrical truss.
WARNING!
In all cases, a safety cable should also be fixed between the safety cable
mounting point located at the bottom of the fixture base housing and the
truss. Failure to use a safety cable could result in injury or death. High End
Systems supplies the proper safety cables and may be contacted for
replacements if necessary. For more information go to:
www.highend.com/trusshang
Do not use C- Clamps to mount the DL.3 fixture to truss.
Use the following steps to mount a DL.3 fixture on a standard truss:
1. Due to its size and weight, at least
two people should support the
fixture. Always stand on a firm,
stable surface when mounting a
fixture to its support.
2. Mount the clamps that shipped
with fixture to the mounting
brackets and then attach the two
mounting brackets to the base of
the fixture using the provided
quarter-turn screws. Tighten the
clamps firmly to the fixture's base
and to the support.
DL.3 Digital Light User Manual
Safety cable loop
CHAPTER 2
Setup and Configuration
Bracket screw holes
11