Mounting The Fixture Upright; Truss Mounting - High End Systems DLHD High Definition Digital Light User Manual

Mounting the Fixture Upright

CAUTION!
Do not mount the fixture upright without the four rubber feet
attached.
To mount the fixture upright, place the fixture on a sturdy, stable surface that will support more
than the 63.5 kg (140 lb) weight of the DLHD fixture. If the surface is above floor height, use
safety cables to secure the fixture to the surface.

Truss Mounting

When mounting the fixture on a truss or another type of support:
• Verify the truss or support will handle the combined weight of all the devices on the truss.
• Always mount the DLHD fixture with the mounting bracket assembly that shipped with your
fixture and a safety cable attached (using the mounting bracket) to the fixture's base.
WARNING!
Before mounting, disconnect power to the fixture. If it has been
operating, allow the fixture to cool for five minutes before handling.
CAUTION!
Do not use C- Clamps to mount the DLHD fixture to truss.
Use the following steps to mount a DLHD fixture on a standard truss:
1. Due to its size and
weight, at least two
people should support
the fixture. Always
stand on a firm, stable
surface when mounting
a fixture to its support.
2. Mount the clamps that
shipped with fixture to
the mounting brackets
and then attach the two
mounting brackets to
the base of the fixture
using the provided
quarter-turn screws.
DLHD Digital Light User Manual
Safety
cable loop
CHAPTER 2
Setup and Configuration
Bracket screw holes
9