Chapter 6:
General Maintenance and Troubleshooting
This chapter outlines safety and maintenance procedures as well as troubleshooting
error messages.
Safety Considerations
CAUTION: The information in this chapter is intended to assist qualified
WARNING: To avoid electrical shock, disconnect power before servicing.
Maintenance
There are no serviceable parts inside the device . The following points have to be considered when
inspecting the fixture for maintenance:
• All screws for installing the devices or parts of the device have to be tightly connected and
must not be corroded.
• There must not be any deformations on the housing, color lenses, fixations and installation
spots (ceiling, suspension, trussing).
• Mechanically moving parts must not show any traces of wearing and must not rotate with
unbalances.
• The electric power supply cables must not show any damage, material fatigue or sediments.
Cleaning the Fixture
• Clean the outside of the lens each week to avoid the weakness of the lights due to
accumulation of dust.
• A detailed electric check by approved electrical engineer each three month, make sure that
the circuit contacts are in good condition to prevent overheating.
To clean fixture lens and components:
1. Disconnect power to the fixture. If the fixture has been operating, allow the fixture to cool
before handling.
2. Clean using a moist, lint-free cloth. Never use alcohol or solvents.
SHAPESHIFTER User Manual
personnel only.
Allow the fixture to cool before handling.
45