Chapter 5: General Maintenance; Figure 5-1 Removing And Replacing The Bezel - High End Systems x.Spot User Manual

Chapter 5:
General Maintenance
The x.Spot fixture is designed for simple maintenance. Modules are easily removed
for repair or custom configurations. The module driver boards are identical using
orientation to differentiate their function for a specific module.
The following toolset is sufficient for the maintenance procedures in this chapter:
• 2.0, 2.5, and 3 mm allen wrench
• Flathead screwdriver
• Gloves
• Protective eyewear
This chapter includes information on replacing parts, and cleaning the fixture. Please
note the warnings under each heading before servicing the fixture.
Warning: This fixture must be serviced by qualified personnel. The
information listed in this chapter is intended to assist qualified
personnel only.
Several of the maintenance operations described in this chapter require bezel
removal. To remove the bezel, loosen the three (3) captive screws on each side of the
fixture head with a flathead screwdriver. Lift the bezel sides away from the base and
toward the lens, see Figure 5-1.When replacing the bezel, ensure that it is fitted
securely in the yoke channel on both side of the fixture as shown in Figure 5-1.

Figure 5-1 Removing and replacing the bezel

Captive Screws
x.Spot ™User Manual
Bezel channel in
yoke arm
General Maintenance
5
5-1