The Boot Option Menu - Husky MP2500 Manual

/l
/mswitch
/ooemid
/pswitch
/sserialnumber
/wswitch
/xpassword
Note: Certain switches are accepted for compatibility with the H
but are otherwise ignored on the MP2500.
The switches may be used in any order and in any combination, except that
the serial number and oem string commands require the password switch
too. You must leave a space between each one and the next.
Caution: The unit will immediately reboot after using any of these switches.

10.2 The BOOT OPTION menu

You can use the Boot Option menu to choose which drive to boot from, and
to change the drive order if two internal drives are fitted (the standard
CompactFlash drive and an optional ATA PC Card).
To use the Boot Option menu:
1. Reset the unit by holding down S + S + P .
2. If the Welcome screen is displayed, press E to acknowledge it.
3. Immediately press A
a flashing cursor will be displayed at the left-hand side of the screen,
below the H
USKY
76
Displays the non-volatile settings on the screen and
the unit's serial number.
Ignored.
Sets the unit oem string to oemid.
Ignored.
Sets the unit serial number to serialnumber.
Enables the welcome screen if switch=1, disables it
if switch=0.
Supplies the password required for the /s, /o, and
/p commands.
A + 1 1 . The normal boot process will terminate and
A A 1 1
copyright message. (If not, repeat steps 1-3.) Type the
H MP2500 System Developer's Guide
USKY
FS3
USKY