Exchanging Files With An Mp2500, Fs3 Or Fs/2; Troubleshooting - Husky MP2500 Manual

14.10.1 Exchanging files with an MP2500, FS3 or
FS/2
The FS/2 comms utility COM.COM is not supplied on MP2500 (or on FS3).
H recommends that files are transferred via a PC, using HCOM (see
USKY
section 14.5). Alternatively, you could load COM.COM onto the MP2500 -
contact your system provider or H
Set up and connect the two systems as described in section 13.7.

14.11 Troubleshooting

If you are using one of the H
to its documentation for a description of its error messages.
If you cannot get communications to start:
•
Check that the port is configured correctly to suit the cable and host.
•
Check the cable and any intervening devices (such as modems,
telephone lines, opto-isolators or line buffers).
•
Check that the host is ready to communicate.
•
If possible, swap components (modems, cables, telephone lines) to
help trace the problem.
If communications works but data is corrupted:
•
Check that the MP2500 and host are using the same data formats and
speeds.
•
Check that all connections are noise-free.
•
Try a slower speed or more secure protocol if one is available.
If communications fails after operating correctly for a time:
•
Check for noisy lines (or use a slower speed or more secure protocol).
158
for details.
USKY
file transfer utilities (HCOM or XL), refer
USKY
H
USKY
MP2500 System Developer's Guide