Husky MP2500 Manual page 103

6. Select option 4, Floppy disk & configure Compact Flash and
press E - this will prompt you for the port being used to connect the
diskette drive:
7. Select option 2 to connect to the PC, then press E.
8. The following screen prompts will be displayed:
9. Select the speed option, then press E. The unit will boot from the
diskette in the PC's drive.
10. On the unit, type B:FDISK E and use options 1 and 2 to create a
DOS partition and set the active partition to C. Exit FDISK and the unit
will reboot (from the HUD in the PC's diskette drive).
11. On the unit, type B:FORMAT C: /S E to format drive C and copy
the operating system files to it.
12. On the unit, type B:IMAGE E to run the IMAGE.BAT file, to copy
the default files to the drive C.
13. Reset the unit by holding down S + S + P. (If the Welcome screen is
displayed, press E to acknowledge it.) Immediately press A + 1.
Now type YKSUH E to display the boot menu again.
14. Select option 1 to make the CompactFlash the boot device, and press
E - the unit should now boot as normal.
Chapter 10: The Utilities 81