Husky MP2500 Manual page 68

Procedure
To recharge using the AC adaptor
recommended:
1. Switch off the MP2500.
2. Plug the AC adaptor into the MP2500 9 way D-type connector. Push the
plug in until the outer sleeve is flush with the casing.
3. Plug the AC adaptor into the AC outlet.
4. Switch on the AC outlet.
5. Charging should begin, indicated by the screen displaying the message
Charging in progress. (If it does not, make sure that charging is
enabled - see section 11.5.) Wait for the batteries to charge fully.
6. If convenient, you may leave the batteries to charge overnight. You may
also disconnect the AC adaptor before the batteries are fully charged if
you need to.
7. When charging is finished, turn off or disconnect at the AC outlet, then
disconnect the AC adaptor from the MP2500.
You may turn on and use the MP2500 even during charging.
As with all electrical apparatus, the AC adaptor should be disconnected
from the AC outlet when not in use. Only 240V AC (220 to 250V), 50 or 60
Hz is suitable for standard units. AC adaptors for alternative supplies, such
as 110V, are available.
If batteries will not recharge
Your application may have disabled charging. Read your application's user
instructions to see how to enable charging.
To check, use the HOT key: press WH, select the Power option, then
press E:
•
If Battery Charging Support is set to Disabled press J to
move to it and press G to change it to Enabled and accept the
change by pressing E and then C to return to the DOS prompt.
46
the following procedure is
H MP2500 System Developer's Guide
USKY