Table of Contents
Advertisement
File not found
ED could not find the file specified in the ED command. EXIT, then check
your typing. Remember that the filename must come before any options.
Filename contains invalid chars
Self-explanatory. Refer to your MS-DOS manual for full details of file
names.
Invalid directory path
Self-explanatory. Refer to your MS-DOS manual for full details of path
names.
Invalid filename
Self-explanatory. Refer to your MS-DOS manual for full details of file
names.
Invalid option
You have included an option in an ED command which is not one of those
specified in section 12.4. Remember that options come after the filename
and must be separated by / characters.
Move invalid: cursor within block
You have tried to move a block into itself. Move the cursor outside the block
and try again.
No block marked... press any key
You have tried to use a block command (BLOCK COPY, MOVE, DELETE
or WRITE) but have not defined the block. Press any key to continue. Use
BLOCK START and BLOCK END to define the block.
No files found
You have specified a pathname in the DIRECTORY command that does
not match any files.
Replace failed...
ED could not find the specified text in the file, or there was insufficient room
in memory to make the replacement. Remember that searching starts at
the cursor position and the specified text must match exactly. If you think
the problem may be with capitalisation, use the case-ignore option (SET
command).
Search failed...
ED could not find the specified text in the file. Remember that searching
starts at the cursor position and the specified text must match exactly. If you
116
H
MP2500 System Developer's Guide
USKY
Advertisement
Table of Contents
Troubleshooting
