Husky MP2500 Manual page 78

•
Release that end of the strap.
Lift the retainer from the other
end to unclip it and the hooks
should slide
recesses.
•
You should now be able to
remove the strap from the
MP2500.
To fit a new hand strap, familiarise yourself with the main diagram above,
then:
•
Turn the MP2500 over.
•
Fit the hooks at one end of the strap into one set of recesses. Press the
plastic retainer into the recesses.
•
Grip the retainer at the other end of the strap and stretch the strap to
reach the other set of recesses.
•
Insert the hooks and let go. The strap should snap into place. Press the
retainer into the recesses and the job is complete.
•
Check that the hooks are properly seated (the retainers are flush with
the MP2500 case) and that the strap is firm.
56
from their
H MP2500 System Developer's Guide
USKY