Configuring Ibm Communications - Husky MP2500 Manual

13.6 Configuring IBM communications

Standard IBM communications will be selected by any standard application
or command that
configuration is as follows:
(All handshake lines are inactive and interrupts are disabled.)
You can alter all these settings from MS-DOS command mode, by using the
standard MS-DOS MODE utility. For example, to select 4800 Baud, 8 data
bits, odd parity, 1 stop bit and no timeout for COM2, type:
MODE COM2 48,O,8,1,P E
Note that the following IBM PC-compatible settings are not supported:
Data bits: 5, 6
Parity: 1 (fixed)
Stop bits: 1.5
These limitations are unlikely to affect you in practice, as these settings are
very rarely used.
Note: For details of the MODE utility, refer to any standard MS-DOS
user's guide.
Chapter 13: Introduction to Communications
initialises communications.
Speed:
Data bits:
Parity:
Stop bits:
Retry on timeout:
E E E
The default
2400
8
No
1
No
COM2
139