Husky MP2500 Manual page 191

Disks:
Printer:
Serial ports:
As part of the configuration process, you may have to make changes to
CONFIG.SYS and AUTOEXEC.BAT. You may find the ED utility useful for
this. Note that if you change the PATH, you should include C:/ on it if you
want to continue to provide easy access to COMMAND.COM, UTIL and ED
(the text editor).
MP2500 provides a slightly unusual environment, so note the following
when setting up these files:
CONFIG.SYS
AUTOEXEC.BAT
Chapter 17: Installing Standard Applications
The standard
CompactFlash drive, configured as drive C, which
behaves like a hard disk.
The standard MP2500 is fitted with a single serial
port (COM2), with the system configured to
automatically redirect printing to LPT1 to COM2.
One (COM2) on MP2500 as standard.
Using the internal disk (drive C), there is no need
for a BUFFERS command, since this disk is very
fast. This will leave more main memory for your
applications.
Standard DOS
ANSI.SYS) are in the C:\DOS directory.
Remember that this file is only executed when
MP2500 is booted.
A desktop computer boots each time it is turned
on or Ctrl-Alt-Del is pressed, but MP2500 will
normally only reboot if you use emergency
breakout or the hardware reset sequence (see
Part 2) which ordinary users should not know
about (an application will usually disable Ctrl-Alt-
Del reboot).
Turning off and on will therefore normally restore
the same environment eg leaves the current
application running,
environment variables, current directory, etc. (You
MP2500 disk
device drivers
restores
drive is the
(such as
the display,
169