Command Line Switches - Husky MP2500 Manual

Move the highlight to the field that you want to change, by using the I or
J key, then adjust the value by using the G or H key. Press E to
accept the changes and return to the main UTIL menu, or press C to
cancel the changes.
To disable the Welcome screen (so the unit boots direct to DOS), set
Welcome screen to Not display. (The default is Display.)
If the backlight option is fitted: to make the backlight turn back on when the
user presses any key after it times out, set EL resume mode to Yes. (The
default is No - the backlight does not turn on again automatically after it
times out.) No is is recommended as it helps maximise battery life.
The charging current can be increased to take account of the higher
capacities of NiMH batteries, compared to NiCd, to ensure that an overnight
charge rate is still achieved. Set Charging type to NiCad or NiMH as
appropriate. The default is NiCad.
If you make any changes in this menu, the unit will reboot when you exit this
screen, to bring the changes into effect.
Note: You can also perform non-volatile configuration by using command
line switches. For details, see section 10.1.7, Command line
switches.

10.1.7 Command line switches

The UTIL command line switches are as follows:
/aswitch
/bswitch
/eswitch
/fswitch
/iswitch
Chapter 10: The Utilities
Ignored.
Enables COM2 if switch=1, disables it if switch=0.
Selects the new backlight mode if switch=1, selects
the old backlight mode if switch=0.
Enables powersave STOP mode if switch=1,
disables it if switch=0.
Ignored.
75