Husky MP2500 Manual page 84

Symptom
Battery life is
shorter than
expected
Powers up in
an application
Don't know
how to leave
application
62
Cause - remedy
This is normally caused by the application preventing
the MP2500 from entering Power Save mode. In our
experience, this can be overcome - contact the H
Support Department or your system supplier for
assistance. See also Appendix G4.
This will happen if an application was running when the
MP2500 was turned off.
- If you want to use an MS-DOS command or a different
application, leave the application as described in its
user instructions. This will take you to MS-DOS
command mode and preserve all your application's
files.
- If the user instructions don't tell you how to leave the
application, ask your system provider.
- If this does not help, press T+W+C or T+C which
should take you to MS-DOS command mode.
OR reboot by pressing T+A+D. (If the program
starts automatically on a reboot, press left S+1 or
T+W+C or T+C during the reboot to prevent this.)
- If neither method works, see 'Can't leave application',
below.
CAUTION: Either method will corrupt any files that the
application is writing to at the time, so use them only as
a last resort.
H MP2500 System Developer's Guide
USKY
USKY