General Endurance Menu - MUTOH Valuevet VJ-628X Maintenance Manual

5.11 Endurance Running Menu
5.11.9

General Endurance Menu

This menu is used to perform endurance running on the CR line (CR motor , Bearing, Tube,
etc) and PF line (PF motor, etc) simultaneously.
The available settings are shown below.
Set item Contents
Speed CW Set Carriage running
Speed CCW speed (CW direction,
CCW direction).
Width Set the shift distance
of the carriage.
Feed Amount Set the media feed
amount per
endurance running
cycle.
LifeCount Set the number of
endurance running
cycles.
• In the general endurance menu, the following operations are performed as one
cycle of endurance running:
The counter indicates above-mentioned set number, and the count number
counts the same value as the only CR motor endurance, etc.
• Carriage stroking: 1 stroke
• Media feed: 1 cycle
• If the number of endurance running cycles is set to -1, Carriage and PF Motor
continuously repeat stroking until it is canceled from Operation panel.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-
digit number). If the number of cycles exceeds the maximum value, the counter
displays 99999999.
5.11.9 General Endurance Menu
Set value Note
310 / 320 / 400 / 420 Unit: cps
400 to 757 Unit: mm
0.1 to 100.0 Unit: mm
-1, 1 to 10000 -
[Enter]
[Enter]
[Enter]
[Enter]
[Enter]
[Enter]
[Enter]
[Enter]/
Completing endurance or [Cancel]
[Cancel]
VJ628XE-M-00
Change the value by pressing[+] /[-] key.
CW-speed(310/320/400/420)
CCW-speed(310/320/400/420)
400mm to 757
Media feed amount(0.1 to 100mm)
Endurance count
Performing endurance running
339