General Endurance Menu - MUTOH ValueJet Service Manual

5.13.5 General Endurance Menu

This menu performs the general endurance running.
You can operate various driving systems according to your desired settings.
The available settings are shown below.
Set item
Running speed (CW,
CCW)
Media feed amount
Number of endurance
running cycles
TIP
• In the general endurance menu, the following operations are performed as one cycle of endurance
running
• Carriage stroking: 1 stroke
• Media feed: 1 cycle
• If the number of endurance running cycles is set to -1, the carriage continuously repeats stroking
until cancel input is given from the operation panel.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-digit number). If
the number of cycles exceeds the maximum value, the counter is reset to 0.
AP-74109 Rev 1.1
Table 5-23 Set Items in General Endurance Menu
Contents
Set the carriage running
speed (CW direction,
CCW direction)
Set the media feed
amount per cycle
Set the number of
endurance running cycles
[Enter] key
[Enter] key
[Enter] key
[Enter] key
[Enter] or [Cancel] key
ValueJet 1304 Service manual
Set value
100, 120, 160, 200, 240m
320, 400
0.1 to 100
-1 to 10000
CW-speed
CCW-speed
Media feed amount
Endurance count
Performing endurance running
5-72
Remark
Unit: cps
Unit: mm