General Endurance Menu - MUTOH ValueJet VJ-1324 Maintenance Manual

5.12 Endurance Running Menu
5.12.8

General Endurance Menu

This menu is used to perform endurance running on the CR line (CR motor Assy , Bearing, Tube, etc)
and PF line (PR motor Assy , etc) simultaneously.
The available settings are shown below.
Set item Contents
Running speed Set Carriage running speed
(CW, CCW) (CW direction, CCW
direction).
Media feed Set the media feed amount
amount per endurance running cycle.
Number of Set the number of endurance
endurance running running cycles.
cycles

5.12.8 General Endurance Menu

Set value Remark
320、 400、 420 Unit ： cps
0.1 to 100 Unit: mm
-1 to 10000 -
T I P
• In the general endurance menu, the following operations are performed as one cycle of
endurance running:
The counter indicates above-mentioned set number, and the count number counts the
same value as the only CR motor assemby endurance, etc.
• Carriage stroking: 1 stroke
• Media feed: 1 cycle
• If the number of endurance running cycles is set to -1, Carriage continuously repeats
stroking until it is canceled from Operation panel.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-digit
number). If the number of cycles exceeds the maximum value, the counter displays
99999999.
[Enter]
[Cancel] [Enter]
[Cancel]
[Enter]
[Cancel]
[Enter]
[Cancel]
[Enter]
[Enter]
[Enter] or [Cancel]
VJ1324E-M-02
Change the values by
key
CW-speed
CCW-speed
Media feed amount
Endurance count
Performing endurance running
P.5-79