Pf Motor Endurance Menu - MUTOH Valuevet VJ-628X Maintenance Manual

5.11 Endurance Running Menu
5.11.2

PF Motor Endurance Menu

This menu is used to perform media feeding operation to perform the endurance running of
PF motor .
The available settings are shown below.
Set item Contents
Feed Amount Set the media feed
amount per endurance
running cycle.
LifeCount Set the number of
endurance running
cycles.
• The following table shows the motor transfer parameters to media feed amount.
Speed
Acceleration
Deceleration
• If the number of endurance running cycles is set to -1, the PF motor continuously
repeats endurance running until cancel input is given from Operation panel.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-
digit number). If the number of cycles exceeds the maximum value, the counter
displays 99999999.
[Enter]
[Enter] /
[Cancel]
[Enter]
[Enter]
[Enter]
After completing endurance or [Cancel]
5.11.2 PF Motor Endurance Menu
Set value Remark
0.1 to 100 unit: mm
-1, 1 to 10000 -
35cps
0.05G
0.05G
Change the value (unit to count)
by pressing [+] or [-] key.
Enter a media feed amount
by using [+]/[-] key
Range : 0.1mm to 100.0 mm
Endurance Count
Performing endurance
VJ628XE-M-00
332