Replacing Cutter Holder Assy - MUTOH Valuevet VJ-628X Maintenance Manual

3.8 Replacing Cursor section
3.8.9

Replacing Cutter Holder Assy

● Tools & Jigs & Maintenance part
Name
Cutter Holder Adjusting Jig
Phillips screwdriver No.2
1
Removing R Side Cover.
3.2.2 Removing Side Cover
2
Remove CR Board Cover.
3.8.3 Removing CR Board Cover
3
Remove P_EDGE Sensor and Cutter
Solenoid from CR Board.
3.8.6 Replacing P_EDGE Sensor
4
Remove P EDGE Sensor and Cutter Solenoid
from the clamps on the path.
5
Remove Spring from Height Adjusting Lever.
A : Height Adjustment Lever
B : Height Adjustment Lever Spring
3.8.9 Replacing Cutter Holder Assy
No. Remarks
DG-45003 Exploded View Other
Generic -
products
B
A
6
Remove the screws (2 pieces) retaining Cutter
Holder Assy.
A : Pan-head screw with spring washer and
flat washer M3ｘ8
B : Cutter Holder Assy
7
Remove Cutter Holder Assy From Carriage.
8
Set dedicated Jig on mounting position.
A : Cutter Holder Adjusting Jig
B : Cutter Holder Assy
9
Push Cutter Holder Assy down lightly to
tighten the screws.
A : Pan-head screw with spring washer and
flat washer M3ｘ8
10
To reassemble unit, reverse the removal
procedure.
VJ628XE-M-00
B
A
B
A
A
124