Parameter Update Menu - MUTOH Valuevet VJ-628X Maintenance Manual

5.9 Parameter Menu
5.9.2

Parameter Update Menu

This menu is used to update the adjustment parameters. The parameters that can be updates
through this menu are as follows.
Rear/Edge sensor, Head rank, Uni-D/Bi-D, Margin, Charge flg, DebugBit, Dot control,
Heater flag, Ink Type, Ink combination, Periodic cleaning, Uni/Bi pattern, Media thickness
NOTE
The updated parameters will not be stored in the flash memory unless the system
power is turned OFF.
[Enter]
[Cancel]
[Enter]
5.9.2 Parameter Update Menu
[Enter]
[Cancel]
Uni-/Bi Low Update
Uni-/Bi High Update
Debug Bit
Update Menu
(1) Rear/Edge Sensor
Enter the set values of Rear/Edge sensors.
[Cancel]
[Enter]
[Enter]
When parameter is changed
[Cancel]
[Enter]
VJ628XE-M-00
Press [+] or [-] key to change
the setting values.
VR : 0 255
GAIN : L/H
After updating
317