Case 580SR Service Manual page 571

www.maskinisten.net
Check that the difference of the measurements be-
tween the wheel hubs diameters ends is within the
requested tolerance range.
The nominal toe-in value (A) is referred to the exter-
nal diameter of the wheel hubs flange, therefore the
measured value (M) at the bars ends must be relat-
ed to the ratio between length of the bar and flange
diameter
nominal toe-in= A
If toe-in is incorrect, operate with two wrenches on
the guide rods (1) screwing in and out the two joint
tie rods (3) equally till the toe-in is within the request-
ed tolerance.
After adjusting, screw in the locknuts (2) of the guide
rods (1) to the specified torque.
SECTION 27 - REAR AXLE
→
measured toe-in= M
-2 -5
Copyright ©
0
A
- 2
A
M 0
- 5
M
3
1
3
1 2
79
F27342
1
F27343
F27344