Case 580SR Service Manual page 544

www.maskinisten.net
52
Position the axle on supports fitted to hold either the
central body or the axle-beam, even after their dis-
junction, or secure the three disjointed groups to a
lifting device with ropes or belts.
Unscrew the screws (2) to disassemble the axle
beam trumpet (1).
Remove the axle beam trumpet (1).
S
WARNING
Once the axle beam trumpet has been removed, the
brake disks are free.
Remove the O-ring (4).
Remove the disks (9) and the intermediate disks
(10).
Remove the gear (8), the remaining brake disk and
the brake counterdisc (15).
Secure the brake flange (7) to a hoist with ropes or
safety belts.
Unscrew the upper screw (5) and the lower screw
(6). Remove the flange (7) from the central body, to-
gether with the bevel gear backlash-adjusting ring
nut.
S
DANGER
This operation frees the differential box, that acci-
dentally could fall.
SECTION 27 - REAR AXLE
8
2 1
4
1
15
10
9
Copyright ©
F28033
F28034
F28035
5 6
7
F28036