Case 580SR Service Manual page 200

www.maskinisten.net
134
17. Disconnect the 12 pin connector from the trans-
mission valve chest mounted to the left hand
side of the of the transmission.
18. Disconnect the transmission to lock out valve
pipe.
19. Disconnect lock out return pipe and plug the hole
(oil will leak out of transmission).
20. Remove front drive shaft (where fitted) and re-
move rear drive shaft.
21. Disconnect the parking brake cable.
22. Disconnect and pull back hydraulic pump (leav-
ing all pipes attached). Check that the oil pump
drive shaft does not slide out with the pump.
23. Check return from steering motor is on the out-
side of transmission oil level tube.
24. With the engine supported and using a "hoist"
capable of supporting a total weight of 800 kg
loosen and remove the engine and transmission
mounting bolts.
IMPORTANT: if the hydraulic oil pump is removed
from the transmission / engine assembly the bal-
ance of the assembly when hoisted will be front end
heavy.
25. Using the lifting tool for the engine-transmission
assy (1) 380300030, raise and extract the en-
gine/transmission assy from the vehicle.
SECTION 21 - TRANSMISSION
Copyright ©
F27736
F27737