Case 580SR Service Manual page 538

www.maskinisten.net
46
Grease well the king pin housings with specific
grease.
Position the belleville washers (23) and (29).
If previously removed, assemble the king pins (24)
and (27) onto the king pins (16) and (18).
Secure the swivel housing (14) with a belt or a rope
to a hoist or to any other supporting device.
Protect the splined end of the axle shaft by winding
it with an adhesive tape to avoid damage to the seal
ring.
Assemble the king pins, the lower (16) and the up-
per (18), and tighten the retaining screws (17) and
(19) to the requested torque.
SECTION 27 - REAR AXLE
24
18
28
27
16
17 19
16
Copyright ©
23
F28046
F28027
14
F27257
18
F27263