Case 580SR Service Manual page 1033

www.maskinisten.net
Copyright ©
SECTION 82 - LOADER 7
3. LOADER ATTACHMENT SAFETY STRUT
Located on the left-hand side of the loader attach-
ment, this safety strut enables the loader attach-
ment to be locked in the raised position in case of
defects in the system.
LOCKED POSITION
Completely raise the loader attachment. Stop the
engine and remove the starter switch key.
Remove the split pins (1) and the safety strut (2)
from the arm. Put the split pins back in place.
Place the strut (2) on the cylinder rod and fasten it
by means of the fastening flip (3).
UNLOCKED POSITION
9
Remove the flip (3) and the strut (2) from the cylin-
der rod.
10
Install the safety strut (2) on the loader arm by
means of the split pins (1).
Start the engine and lower the loader attachment.
11