Case 580SR Service Manual page 537

www.maskinisten.net
Collect the belleville washers (23) and (28).
Position the swivel housing (14) on a flat surface
and extract the seal ring (22) with a lever.
NOTE: this is a destructive operation for the seal
ring.
Turn the swivel housing and take the bush (26) out,
using a suitable drift and a hammer.
Assembly
If it has been previously removed, reassemble the
steering stop composed by the screw (21) and nut
(20).
NOTE: do not tighten the nut (20) until the steering
angle adjustment has been done.
Force the bush (26) into the swivel housing (14) us-
ing the special tool 380002668 and a hammer.
Insert the seal ring (22) into the swivel housing (14)
with the special tool 380002669 and a hammer.
Grease carefully the seal ring (22).
SECTION 27 - REAR AXLE
26
Copyright ©
28
23
22
14 23
20
45
F28046
F27259
21
F27260
14
22
F28047