Case 580SR Service Manual page 362

www.maskinisten.net
10
Insert the thrust washer (5) into the front support
seat.
Heat the bush (4) at 110 ÷ 120 °C then assemble it
to the axle housing (6).
NOTE: if necessary assemble the bush (4) with a
pad and a hammer.
Apply sealant on the bushes (1) contact surface.
Assemble the bushes (1) to the front support (2) with
a pad and a hammer.
Assemble the bush (3) into the front support (2) with
a suitable driver and a hammer.
S WARNING
Align the bush hole with the bolt (8) hole.
Mount the bolt (8).
Insert the front support (2) on the axle housing (6).
Tighten the bolt (8) to the request torque and tighten
the lube nibble (9).
SECTION 25 - FRONT AXLES
6 5
1
2
2
3
2
6
Copyright ©
4
F27359
F27362
8
F27363
8
9
F27364