Case 580SR Service Manual page 719

www.maskinisten.net
2. REMOVAL AND INSTALLATION COMPONENTS
2.1 COMPONENTS WITHIN THE CHASSIS
ENGINE
Supported by 2 rubber silent blocks and held in po-
sition by 2 support brackets. The brackets, which
are welded to the frame one either side of the en-
gine are positioned just ahead of the loader posts.
S WARNING
The engine and transmission bolted together act as
a one piece unit. If separated in the machine they
are not self supporting and will collapse causing in-
jury or damage to the machine.
TORQUE CONVERTER
Fitted between the engine and the transmission can
only be removed when the engine/transmission as-
sembly are separated.
TRANSMISSION
Attached to the rear of the engine and supported in
rubber silent blocks in fixed brackets and held within
the frame just at the rear of the loader post.
To make repairs that require disassembly of the
transmission or engine it will be necessary to re-
move the engine/transmission as a complete unit
from the chassis.
SECTION 39 - CHASSIS
To remove the engine/transmission from the ma-
chine it will be necessary to remove or disconnect
the following:
Remove:
Air filter
Engine guard
Radiator's and related hoses (Or pivot forward
where possible)
Front support cowling (if required)
Disconnect:
Fuel pump throttle cable and electric shut off
Engine harness
Fuel tank connection and leak off return pipes
Hydraulic pump and related pipework (plug all ports
as required)
Transmission Lever
Transmission harness connectors
Engine supports (with engine supported by hoist)
Transmission supports
Copyright ©
5