Case 580SR Service Manual page 539

www.maskinisten.net
Position the wheel hub (11) on a workbench and as-
semble the bearing cups (9) and (12) in position with
the special tool 380002222 under a press or with a
hammer.
Assemble the seal ring (13) into the wheel hub (11)
with the special tool 380002213 and a hammer.
Assemble the bearing (12) onto the swivel housing
end (14).
Assemble the wheel hub (11) on the swivel housing
(14) and fit the bearing (9).
Position the ring gear carrier (7) on a workbench
and force the bushes (6) to the carrier (7) surface
level with the special tool 380002667.
At least two bushes (diametrically-opposed) should
be set slightly higher than the carrier surface level to
be used as dowel pins.
Preassemble the ring gear carrier (7) and the ring
gear (4) with the retaining ring (8).
SECTION 27 - REAR AXLE
6
Copyright ©
9 12 13
11 11
14
12 9
7
8
7
4
47
F28028
F27265
F27266
F27267