Case 580SR Service Manual page 516

Hide thumbs Also See for 580SR:

Table of Contents

www.maskinisten.net

DIFFERENTIAL BEARING PRELOAD

This adjustment is made by shimming the right hand

differential bearing cone.

The value of following shimming is required: dimen-

0.034 ÷ 0.039

0.040 ÷ 0.045

0.046 ÷ 0.051

0.052 ÷ 0.057

0.058 ÷ 0.063

0.064 ÷ 0.069

0.070 ÷ 0.075

0.076 ÷ 0.081

Remove the differential bearing cone and shim from

the outer brake housing.

Place the gauge ring of tool 380000991 (1) into the

vacant bearing location.

Screw bridge tool 380000991 (1) across the rear

axle housing flange with spacers (2) located be-

tween the axle housing flange and the tool.

Measure the gap between the bridge tool and the

gauge ring using a feeler gauge (3).

Refer to the table to determine the correct size shim

which should be installed between the brake hous-

ing and bearing cone, thus preloading the bearing

back to specifications.

SECTION 27 - REAR AXLE

Show Quick Links

Chapters

Table of Contents

580sr+590sr 695sr