Case 580SR Service Manual page 199

www.maskinisten.net
Copyright ©
SECTION 21 - TRANSMISSION 133
2.10 TRANSMISSION REMOVAL AND INSTALLATION
REMOVAL
S
WARNING
Before performing any service or maintenance on the machine ensure the wheels are chocked/blocked to pre-
vent the machine from moving.
1. Lower the loader to the ground or raise and secure (dependent upon lifting apparatus) and release any
pressure in the system as required. Engage the parking brake and block the wheels.
2. Stop the engine.
3. Isolate battery.
4. Remove all engine panels.
5. Remove front cast cowling.
6. Drain engine coolant and remove hoses.
IMPORTANT: air conditioning where fitted - Do not disconnect the air conditioning hoses from the compressor
or condenser unless a refrigerant reclaim system is to be used. Engine/Transmission removal from the ma-
chine does not require the system to be discharged.
Remove the condenser from the front radiator and place the condenser to one side of the chassis.
Disconnect the air conditioning compressor attaching hardware and place the compressor to one side of the
chassis.
Disconnect the expansion bottle connections from the radiator.
7. Remove all attaching bolts from radiator.
8. Disconnect transmission cooler pipes.
9. Remove radiator, taking care not to damage the fan or hydraulic oil cooler.
10. Remove the air filter assembly.
11. Disconnect all electrical connections.
12. Disconnect hydraulic pipe clamps.
13. Disconnect the fuel tank feed and return pipes.
14. Disconnect the foot throttle cable at the fuel injection pump.
15. Remove the cab mat.
16. Remove the cab floor access panel.