Case 580SR Service Manual page 146

www.maskinisten.net
Copyright ©
80 SECTION 21 - TRANSMISSION
Attach a suitable shimming tool 380002693, to the
end of the countershaft.
Position a D.T.I. as shown, and using a pry bar lift
the shaft, then measure and note the end float.
Attach a suitable shimming tool 380002693, to the
end of the output shaft. Position a D.T.I. as shown,
and using a pry bar lift the shaft, then measure and
note the end float.
Attach a suitable shimming tool 380002693, to the
end of the 4WD shaft. Position a D.T.I. as shown
and, using a pry bar, lift the shaft, then measure and
note the end float (on 4WD models only).
Remove the rear case and add or remove shims as
necessary to give 0.025 to 0.076 mm end float on all
shafts.
Repeat steps 17 to 22 until all shaft end floats are
correct.
Replace the 4 O-rings in the front case (on 2WD
models, there are only 3 O-rings).
NOTE: the input shaft and 4WD shaft sealing rings
should now be fitted.