Case 580SR Service Manual page 814

www.maskinisten.net
54
FAULT FINDING
During diagnosis follow the inspections procedures in the sequence shown until a default is found. Then per-
form the repair in the "Cause and Remedy" section. If this repair does not fully solve the problem, proceed to
the next inspection step.
PROBLEM
Unusually high suction pres-
sure with unusually low dis-
charge pressure
Unusually low suction and dis-
charge pressure
Intermittent or inoperative
Rough running
PROBLEM
Clutch engaged
Clutch disengaged "chattering" Check air gap
SECTION 50 - CAB HEATING AND AIR CONDITIONING
Valve plate test
Check for low refrigerant charge
Leak check compressor
Leak check and diagnose system
Check belt tension
Check clutch air gap
Check clutch volts, amps, coil lead
wire
Shaft turning smoothness test
Check compressor mounting compo-
nents
Check engine components
Check for intermittent or slipping
clutch
Check for proper refrigerant charge
Check clutch bearing
Oil level procedure
Shaft turning smoothness test
Remove valve plate and inspect
CAUSE
Replace or repair:
Broken head or block gasket.
Broken or deformed reed valve.
Foreign substance under reed valve
or gasket.
Replace or repair:
Shaft seal leak.
Cylinder head leak.
Gasket leak.
Oil filler plug leak.
Cracked cylinder block.
Front housing O-ring leak.
Replace.
Adjust air gap.
Replace or repair:
Broken lead wire.
Clutch coil defect - Internal.
System ground (see system man-
ual).
Compressor failure - Internal.
CAUSE
Replace or repair.
Replace or repair.
Adjust air gap - defective coil.
Recharge and recheck.
Replace rotor / Armature assembly.
Fill to proper level.
Compressor failure (Internal).
Replace or repair:
Broken discharge valve reed or
retainer.
Broken suction valve reed.
Broken gasket.
Replace or repair:
Adjust air gap.
Defective clutch pulley or front plate.
Copyright ©
CORRECTION
CORRECTION