Case 580SR Service Manual page 440

www.maskinisten.net
88
Assemble the bush (8) in the rear support (5).
S
WARNING
Align the bush hole with the bolt (4) hole.
Mount the bolt (4).
Lubricate with grease a new O-ring (7).
Insert the O-ring (7) in the rear support (5).
Insert the rear support (5) on the differential support.
S
WARNING
Do not damage the O-ring when inserting the rear
support on the central body.
Tighten the bolt (4) to the specified torque.
Assemble the lube nibble (9).
Insert the washer (16) into the front support seat.
Heat the bush (17) at 110÷120 °C then assemble it
to the axle housing (20).
NOTE: if necessary assemble the bush (17) with a
pad and a hammer.
SECTION 25 - FRONT AXLES
5
5
7
4
9
17
15
Copyright ©
8
4
F27216
5
F27215
F27391
16
F27390