Case 580SR Service Manual page 402

www.maskinisten.net
50
Assemble both bearing cups (9) and (12) to their
wheel hub (11) housings using the special tool
380002663 under a press or with a hammer.
Insert the seal ring (13) into the wheel hub (11) with
the special tool 380002227 and a hammer.
NOTE: do not lubricate the seal ring (13).
Assemble the bearing (12) on the swivel housing
(14) end.
Assemble the wheel hub (11) on the swivel housing
(14) and fit the bearing (9).
Position the ring gear carrier (7) on a workbench
and force the bushes (6) to the carrier (7) surface
level with the special tool 380002223.
At least two bushes (diametrically-opposed) should
be set slightly higher than the carrier surface level to
be used as dowel pins.
Preassemble the ring gear carrier (7) and the ring
gear (4) with the retaining ring (8).
SECTION 25 - FRONT AXLES
6
9 12
11
14
12 9
7
8
7
4
Copyright ©
13
11
F27264
F27265
F37835
F27267