Case 580SR Service Manual page 448

www.maskinisten.net
96
Unscrew and remove both fastening screws (3) of
the planetary carrier cover (1).
Remove the planetary carrier cover (1) from the
wheel hub.
Position the planetary carrier cover (1) on a work-
bench and check its wear conditions.
If necessary, replace the gears as follows:
Z unscrew the screws (11) on every pin (4);
Z remove the washers (8) and (9);
Z extract the gears (7) from the pins;
Z collect the bearings (7) and check their conditions;
Z collect the washer (6).
NOTE: with the new gears it is advisable to assem-
ble new needles.
Assembly
Position the planetary carrier cover (1) on a work-
bench. Insert the washers (5) and the gears (7) com-
plete with the rollers (6) in the pins of the planetary
gear carrier.
Assemble the washers (8) and fasten them with the
pins (10).
Fit the washers (9) and screw in the screws (11) by
tightening them at the prescribed torque.
NOTE: with the new gears it is advisable to assem-
ble new needles.
SECTION 25 - FRONT AXLES
3
1
1
4
6
5
1
6
5
Copyright ©
3
F27241
F27405
10
11
9
8
7
F27406
10
11
9
8
7
F29008