Case 580SR Service Manual page 147

www.maskinisten.net
Copyright ©
SECTION 21 - TRANSMISSION 81
Refit the rear case using an approved liquid gasket
(Loctite 5203) taking care not to damage the input
shaft or 4WD shaft sealing rings. Tighten the 17
bolts to a torque of 45-64 Nm.
Replace the shaft end plug and O-ring assemblies.
Note the special breather plug is fitted in the reverse
idler position. Tighten to a torque of 41-54 Nm.
Fit a new expansion plug to the shimming access
hole using an approved sealant. (Loctite 649).
Replace the output yoke, the O-ring, the washer and
the bolt. Then tighten to a torque of 68-88 Nm.