Case 580SR Service Manual page 514

Hide thumbs Also See for 580SR:

Table of Contents

www.maskinisten.net

The procedure to determine value X occurs in the

following manner:

Z install the largest shim (for instance 2.286 mm);

Z position the gear assy;

Z screw and tighten screw at 554÷626 Nm;

Z by means of a dial gauge, find out the axle back-

lash (for instance 0.562 mm);

Z subtract endfloat from shim already fitted, for ex-

ample 2.286 - 0.562 mm = 1.724 mm.

The "Resultant value" is obtained.

Z starting from the "Resultant value", refer to the ta-

ble for the correct shim to replace the 2.286 one.

IMPORTANT: increasing shim thickness will reduce

preload. Decreasing shim thickness will increase

Z fit selected shim and re-tighten retained screw to

correct torque and allow lock plate to locate.

SECTION 27 - REAR AXLE

RESULTANT VALUE

1.245 - 1.270 mm

1.346 - 1.372 mm

1.448 - 1.473 mm

1.549 - 1.575 mm

1.651 - 1.676 mm

1.753 - 1.778 mm

1.854 - 1.880 mm

1.956 - 1.981 mm

2.057 - 2.083 mm

2.159 - 2.184 mm

2.261 - 2.286 mm

SHIM TO BE INSTALLED

Show Quick Links

Chapters

Table of Contents

580sr+590sr 695sr