Case 580SR Service Manual page 517

Hide thumbs Also See for 580SR:

Table of Contents

www.maskinisten.net

MEASURING OF RANGE BETWEEN THE FACE THRUST BLOCK AND THE BACK FACE OF

DIFFERENTIAL

For dimensions "S" outside normal gap range use

as required the minimum number of shims to pro-

vide design gap of 0.10 - 0.20 mm.

This procedure has the goal to get a clearance of

0.10 mm to 0.20 mm between the thrust face of the

thrust block and the back face of the differential bev-

To get this setting we perform two measurements to

calculate the shim pack to be used.

Z On the centre housing, with the differential assy in-

stalled and centered, we check the distance from

the back of the bevel gear to the trumpet mounting

face of the centre housing. During this measure-

ment rotation of the differential is needed to get the

shortest reading. This is to take the run-out of the

back face in calculation thus to avoid interference

afterwards (dimension Y).

Y: dimension from back of differential bevel gear to

trumpet mounting face.

A: gauge clamped on housing and differential

aligned to check the dimension "Y".

SECTION 27 - REAR AXLE

87346232 + 87346228

87346232 + 87346231

87346232 + 87346427

Show Quick Links

Chapters

Table of Contents

580sr+590sr 695sr