Case 580SR Service Manual page 391

www.maskinisten.net
Remove the tie rods (3) and (12) by loosing the nuts
(4) and (11) with a suitable wrench, then check the
conditions.
Unscrew the fastening screws (6) and take the
steering cylinder (7) out of its housing, if necessary
use a rubber hammer.
Remove only parts that need to be overhauled and/
or replaced.
Remove the cylinder head (15) from the cylinder
body (19) and remove it from the rod (17).
Remove the rod (17) from the cylinder body (19).
Remove all the seals and O-rings (13, 14, 16, 18, 20
and 21) from the cylinder body (19), the cylinder
head (15), and the rod (17).
Assembly
Assemble new seals and O-rings (13, 14, 16, 18, 20
and 21) on the cylinder head (15), on the rod (17)
and on the cylinder body (19).
Assemble the cylinder head (15) on the rod (17).
Slide the pre-assembled rod (17) into the cylinder
body (19).
SECTION 25 - FRONT AXLES
13
13
11
6
4
3 5
19
16
14
15
19
16
14
15
17
15
19
Copyright ©
39
12
10
7
F27229
21
20
18
17
F27230
21
20
18
17
F27231
F27232