Case 580SR Service Manual page 413

www.maskinisten.net
Once all the adjustment operations have been com-
pleted, fit the ring nut retainers (8) and their screws
(9), tightening them to the requested torque.
Tighten the bolts (12) of both half collars (11) to the
requested torque.
Before matching surfaces, make sure that they are
perfectly clean, degrease and clean them with ap-
propriate detergents.
Spread a film of adhesive on the contact surface be-
tween the axle beam (14) and the differential carrier.
NOTE: check that the two pins (13) are in their
housing.
Position the differential support (1) on the axle hous-
ing (14), and tighten the retaining screws (2) to the
requested torque.
SECTION 25 - FRONT AXLES
14
2
1
Copyright ©
14
13
61
9
8
F27298
12
13
F27299
13
F27300
F27301