Case 580SR Service Manual page 528

www.maskinisten.net
36
Remove the tie rods (3) and (13) by loosening the
nuts (4) and (12) with a suitable wrench, then check
their conditions.
Unscrew the fastening screws (6) and (9) and take
the steering cylinder (7) out of its housing, if neces-
sary use a rubber hammer.
Remove only parts that need to be overhauled and/
or replaced.
Remove the cylinder head (22) from the cylinder
body (18) and remove it from the rod (20).
Remove the rod (20) from the cylinder body (18).
Remove all the seals and O-rings (16, 17, 19, 21, 23
and 24) from the cylinder body (18), the cylinder
head (22), and the rod (20).
Assembly
Assemble new seals and O-rings (16, 17, 19, 21, 23
and 24) on the cylinder head (22), on the rod (20)
and on the cylinder body (18).
Assemble the tie rods (3) and (13), the ball joints (5)
and (11), the nuts (4) and (12) to the ends of the rod,
then tighten with a dynamometric wrench to the re-
quested torque.
SECTION 27 - REAR AXLE
17
17
4
5
7
10
3 6 8 9
16
18
20
19
22
16
18
20
19
22
4
5
7
10
3
Copyright ©
11
12
13
F28014
21
23
24
F28015
21
23
24
F28016
11
12
13
F28017