Case 580SR Service Manual page 368

www.maskinisten.net
16
Loosen and remove the screws (3). Remove the
thrust washer (4).
Remove the wheel hub (7) using levers and a ham-
mer to facilitate the operation.
NOTE: collect the bearing cone (5).
Position the wheel hub (7) on a flat surface and re-
move the seal ring (9) with a lever.
NOTE: destructive operation for the seal ring (9).
Remove the bearing cups (5) and (8) using a ham-
mer and a suitable drift.
Remove the bearing cone (8) from the swivel hous-
ing end, using a suitable extractor.
Unscrew and remove the fastening bolts (12) from
the upper (11) and lower (13) king pin.
S WARNING
Before removing the king pins (11) and (13), secure
the swivel housing (10) to a rope or a hoist or to any
other supporting device; observe all current safety
regulations to guarantee the operator's safety.
Remove the king pins (11) and (13).
SECTION 25 - FRONT AXLES
5
7
12
11 13
Copyright ©
7
5
F27368
9
8
F27255
10
F27370