Case 580SR Service Manual page 1034

www.maskinisten.net
Copyright ©
8 SECTION 82 - LOADER
4. LOADER BUCKET REMOVAL
REMOVAL
Park the machine on flat surface.
Lower the bucket to the ground in dump position (tilt-
ed completely forward).
Stop the engine and remove the starter switch key.
If the machine is fitted with a 4x1 bucket, release the
pressure from the bucket system.
Remove the snap rings and retaining pins and then
drive out the linkage pins (1).
(4x1 bucket) disconnect and plug the hydraulic sup-
ply lines.
Start the engine
Operate the attachment controls so as to release the
bucket.
Reverse the machine from the bucket.
INSTALLATION
Make sure all bushings are completely clean.
Remove any dirt or foreign matter, if necessary.
Start the engine
Use the attachment controls to engage the attach-
ment between the bucket lugs.
Install the arm/bucket linkage pins (1) and then in-
stall the retaining pins and snap rings.
Use the bucket controls to align the connecting rod
holes with the bucket lugs.
Stop the engine and remove the starter switch key.
(4x1 bucket) release the pressure from the bucket
system.
Install the connecting rod/bucket linkage pins (1) and
then install the retaining pins and snap rings.
(4x1 bucket) remove the plugs and reconnect the hy-
draulic supply lines.