Case 580SR Service Manual page 453

www.maskinisten.net
Collect the belleville washers (25) and (26).
Position the swivel housing (14) on a flat surface
and extract the seal ring (23) with a lever.
NOTE: this is a destructive operation for the seal
ring.
Turn the swivel housing and extract the bush (22)
using a suitable drift and a hammer.
Assembly
If it has been previously removed, reassemble the
steering stop composed by the screw (21) and nut
(20).
NOTE: do not tighten the nut (20) until the steering
angle adjustment has been done.
Insert the bush into the swivel housing (14) with the
special tool 380002668 and a hammer or a press.
Insert the seal ring (23) into the swivel housing (14)
with the special tool 380002669 and a hammer.
Grease carefully the seal ring (23).
SECTION 25 - FRONT AXLES
Copyright ©
26
25
22
14 23
20
23 14
22
101
F27413
F27259
21
F27260
F27261