Case 580SR Service Manual page 134

Hide thumbs Also See for 580SR:

Table of Contents

www.maskinisten.net

SECTION 21 - TRANSMISSION

HYDRAULIC MULTI PLATE CLUTCH 4WD SHAFT

Using an appropriately sized tube refit the front bear-

Replace the piston sealing rings to facilitate assem-

bly: the seals may be warmed in lukewarm water pri-

or to assembly.

NOTE: the outer seal must be fitted with the open

edge facing away from the clutch pack.

Using the appropriate tool 380002684 compress the

piston sealing rings. The seals should be left in the

tool 380002684 for a minimum of 30 minutes prior to

assembly into the clutch drum.

Lubricate the seals with a light grease and refit the

piston into the clutch drum. Then replace the spring,

retainer and circlip.

Show Quick Links

Chapters

Table of Contents

580sr+590sr 695sr