Case 580SR Service Manual page 401

www.maskinisten.net
Assemble the spacer (27) in the upper king pin
housing.
If the cone (15) of the spherical joint has been pre-
viously removed, reassemble it to the lower king pin
(16) using the special tool 380002662 under a
press.
Grease carefully the seats of king pin (16) and (18)
with specific grease.
Position the belleville washers (25) and (28) on the
king pin (16) and (18) housings.
Secure the swivel housing (14) with a belt or a rope
to a hoist or to any other supporting device.
Protect the splined end of the axle shaft by winding
it with an adhesive tape to avoid damage to the seal
ring.
Assemble the swivel housing (14) on the axle shaft.
Assemble the king pins, the lower (16) and the up-
per (18), and tighten the retaining screws (17) and
(19) to the requested torque.
SECTION 25 - FRONT AXLES
15
16
18
Copyright ©
49
27
F27258
28 25
25 25
F27262
14
F27257
17 19
16 18
F27263